The bearings allows the hub shell (and the rest of the wheel parts) to rotate freely about the axle. Most bicycle hubs use steel or ceramic ball bearings. Older designs used "cup and cone", whereas some modern wheels utilize pre-assembled "cartridge" bearings. A "cup and cone" hub contains loose balls that contact an adjustable 'cone' that is screwed onto the axle and a 'race' that is pressed permanently into the hub shell. Both surfaces are smooth to allow the bearings to roll with little friction. This type of hub can be easily disassembled for lubrication, but it must be adjusted correctly; incorrect adjustment can lead to premature wear or failure.
In a "cartridge bearing" hub, the bearings are contained in a cartridge that is shaped like a hollow cylinder where the inner surface rotates with respect to the outer surface by the use of ball bearings. The manufacturing tolerances, as well as seal quality, can be significantly superior to loose ball bearings. The cartridge is pressed into the hub shell and the axle rests against the inner race of the cartridge. The cartridge bearing itself is generally not serviceable or adjustable; instead the entire cartridge bearing is replaced in case of wear or failure.
Hub shell
The hub shell is the part of the hub to which the spokes (or disc structure) attach. The hub shell of spoked wheels generally have two flanges extending radially outward from the axle. Each flange has holes or slots to which spokes are affixed. Some wheels (like the Full Speed Ahead RD-800) have an additional flange in the center of the hub. Other (like the some from Bontrager and Zipp) do not have a noticeable flange. The spokes still attach to the edge of the hub but not through visible holes. Other wheels (like those from Velomax/Easton) have a threaded hub shell that the spokes thread into.
In a "cartridge bearing" hub, the bearings are contained in a cartridge that is shaped like a hollow cylinder where the inner surface rotates with respect to the outer surface by the use of ball bearings. The manufacturing tolerances, as well as seal quality, can be significantly superior to loose ball bearings. The cartridge is pressed into the hub shell and the axle rests against the inner race of the cartridge. The cartridge bearing itself is generally not serviceable or adjustable; instead the entire cartridge bearing is replaced in case of wear or failure.
Hub shell
The hub shell is the part of the hub to which the spokes (or disc structure) attach. The hub shell of spoked wheels generally have two flanges extending radially outward from the axle. Each flange has holes or slots to which spokes are affixed. Some wheels (like the Full Speed Ahead RD-800) have an additional flange in the center of the hub. Other (like the some from Bontrager and Zipp) do not have a noticeable flange. The spokes still attach to the edge of the hub but not through visible holes. Other wheels (like those from Velomax/Easton) have a threaded hub shell that the spokes thread into.
No comments:
Post a Comment